cutoff wavelength
英 [ˈkʌtɒf ˈweɪvleŋθ]
美 [ˈkʌˌtɔf ˈweɪvleŋθ]
截止波长
双语例句
- A practical formula to calculate the cutoff wavelength of square and rectangular coaxial lines
一种方形及矩形同轴线截止波长的实用计算公式 - It calculates the cutoff wavelength and single-mode bandwidth at the change of the ridge dimensions, gives the dominant mode field pattern and the corresponding curve of the deformation vs.
计算了脊的尺寸变化时的截止波长和单模带宽，给出了主模场结构图以及变形对截止波长和单模带宽影响的关系曲线，并分析了传输特性随对称脊波导结构尺寸变化的情况。 - Application and Research of the Value Stream at JDS Plant; A practical formula to calculate the cutoff wavelength of square and rectangular coaxial lines
价值流分析在吉林北方捷凯传动轴公司的应用与研究一种方形及矩形同轴线截止波长的实用计算公式 - Measurement of Cutoff Wavelength for double Clad Monomode Fiber& the Modified Polarization Method
双包层单模光纤截止波长测量&改进的偏振法 - Numerical Computation of Cutoff Wavelength of the Dominant Mode in Asymmetric Single Ridge Waveguide
非对称单脊波导主模截止波长的数值计算 - The cutoff wavelength can be adjusted by adjusting the ridge position.
截止波长可以通过脊位置的调整而调整。 - Fundamental mode cutoff wavelength measurement of single polarization single Mode optical fiber
单模单偏振光纤基模截止波长的测量 - The slope of cutoff wavelength versus d/ Λ curve decreases as the order of mode increases.
各阶模式的截止波长随d/∧变化曲线的斜率随模式阶次的升高而降低。 - The cutoff wavelength and the quantum efficiency of PtSi infrared detector are restricted by its Schottky barrier height.
PtSi肖特基二极管的势垒高度制约PtSi红外探测器的截止波长和量子效率。 - Theoretical calculation of cutoff wavelength and attenuation constant in elliptic waveguides
椭圆波导的截止波长和衰减常数的理论计算 - The text computes the eigenvalue of double ridged waveguide, single ridged waveguide and unsymmetry ridged waveguide, transmission of three kinds of ridged waveguides with ridge on the narrow wall are solved for and the useful curves on cutoff wavelength, bandwidth and field pattern are presented.
编程计算了双脊、单脊和不对称脊波导的特征值，求解了三种脊位于窄边的脊波导的传输特性，并给出了截止波长和单模带宽曲线以及场结构变化。 - The cutoff wavelength of ridge waveguide is very closed to the ridge position. It can be changed by changing the ridge position.
脊波导的截止波长与脊位置密切相关，其值可通过脊位置的改变而改变。 - Ridge Position Influence of The Axisymmetry Ridge Waveguides on The Cutoff Wavelength of The Dominant Mode
不对称脊波导脊位置对主模截止波长的影响 - This paper describes the application of finite difference method for obtaining the cutoff wavelength and the field pattern of asymmetric single ridge waveguide, and gives the specific equation for computing related parameters.
提出了用有限差分方法分析不对称脊波导主模的截止波长和场结构图等传输特性，推导出用有限差分方法计算相关参数的公式。 - The Calculation of Cutoff Wavelength of Asymmetric Ridged Waveguide
不对称脊波导截止波长的计算 - The numerical calculation methods of the cutoff wavelength and mode field diameter are described in detail.
给出了数值计算截止波长和模场直径的方法； - In this article, 2-terminal network theory is applied to deduce a formula of the relationship between the standing-wave, ratio at the resonance point of a magnetron and the cutoff wavelength of an H-section-guided output transformer.
本文利用二端网络理论，推出了磁控管谐振点驻波导数与H形输出变换器截止波长之间的关系式。 - In this article, the influences of the mode field diameter, the cutoff wavelength and the relative refractive index difference on the OTDR curve are also verified.
文中还验证了单模光纤的模场直径、截止波长、相对折射率差对OTDR曲线的影响。 - The InAs_ ( 0.04) Sb_ ( 0.96) epilayers with a cutoff wavelength of 12 μ m were successfully grown on semi-insulating ( 100) GaAs substrates using melt epitaxy ( ME).
用熔体外延（ME）法在半绝缘（100）GaAs衬底上成功生长出了截止波长为12μm的InAs0.04Sb0.96外延层。 - The eigenvalue of single-ridge waveguide with the ridge on short side is analyzed by the finite difference method, the normalized cutoff wavelength and the dominant mode bandwidth data about single-ridge waveguide with the ridge on the short side are also given.
用有限差分理论分析了脊位于窄边的单脊波导本征值问题，给出了脊位于窄边的单脊波导的截止波长和主模带宽等一系列数据。 - The Calculation of the Higher Order Modes Cutoff Wavelength in TEM Cells with TLM Method
用TLM方法计算TEM小室高次模的截止波长 - The cutoff wavelength of the rectangular coaxial waveguide in the coupling region is calculated by boundary element method.
其耦合区为矩形同轴波导。文中用边界元素法对矩形同轴波导的截止波长进行了计算。 - In this way, the satisfied values of the cutoff wavelength, the dispersion and the field radius of the fiber can be obtained.
得到了一条适当的设计途径，使这种光纤的截止波长、色散、模场直径等均达到令人满意的值。 - The cutoff wavelength of the fiber can be shifted as desired by tuning the refractive index of the core and the size of the cladding air holes.
通过改变纤芯折射率的大小和包层中空气孔的大小，可以对光纤的截止波长进行调节。 - The chromatic dispersion, cutoff wavelength, mode field radius and tolerance of a structural design of dispersion-flattened single-mode fiber are calculated and discussed.
推导了相应的电磁场分布函数，计算和讨论了一种色散平坦结构方案的色散特性、截止波长、模斑尺寸及工艺容限。 - The cutoff wavelength and approximate solved fields of a cam rectangular waveguide
圆突-矩形波导中截止波长及场的近似解 - When the ridge height is increased, or the ridge width is increased, or the ridge position is closely middle location, numerical results have shown that dominant-mode cutoff wavelength can be increased and bandwidth can be improved in the ridge waveguide.
计算结果显示：当脊的高度越高，或脊的宽度越窄，或脊的位置越接近中部，TE主模的截止波长就将越长，波导带宽就能增加。 - Partially dielectric loaded ridge waveguides have important applications in practical engineering, compared to the non-filling dielectric ridge waveguide, it has longer cutoff wavelength and narrower single-mode bandwidth.
与非填充介质脊波导相比，部分介质填充脊波导有较长的截止波长，较窄的单模带宽等特性。 - By comparing the data we can see that inverted trapezoid ridge waveguide has the biggest cutoff wavelength and single-mode bandwidth, it is more conducive to miniaturization devices design of microwave.
通过对比数据可得到：倒梯形双脊波导截止波长和单模带宽最大，适用于小型化微波器件。